Toro Power Max Service Manual page 56

NON-WHEEL CLUTCH
TRACTION DRIVE SYSTEM
10. Now the shift rod bracket and hex shaft can be
moved to separate the shift rod from the trunion (Fig.
107).
A. Shift Rod
At this point the friction wheel can be replaced. The
hex shaft, sprocket, trunion and spacers are a single
assembly.
8-4
A
B
Fig 107
MVC-1002X.jpg
B. Trunion
11. Remove the hairpin from the speed control link
(Fig. 108). This is most easily accessed from the
top of the machine. The link is on the left side under
the belt cover. Slide the link out of the pulley pivot
assembly.
A. Hairpin Cotter
12. Slip the traction idler off the traction belt. This can be
done from either the top or the bottom. The traction
idler will rotate to this position (Fig. 109).
A
A. Traction Idler
A
Fig 108
MVC-897X.jpg
Fig 109
MVC-1003X.jpg
Power Max Service Manual