Toro Power Max Service Manual page 85

If the auger cover is to be removed the fi rst step is to
remove both of the belt covers (Fig. 214).
The auger cover is attached to the auger housing with
carriage bolts and locknuts (Fig. 215).
Power Max Service Manual
Fig 214
MVC-893XA
Fig 215
MVC-898XA
DISCHARGE CHUTE
Assemble in reverse order. The metal seal is installed
under the mounting fl ange on the left rear corner of the
auger housing. (Fig. 216).
Note: Do not over-tighten to the point the cover
starts to deform. Just seating the nut is
enough; the nylock feature will keep if from
loosening.
Fig 216
MVC-849X
10-3