Fuel Tank, Fuel Line, Fuel Filter; Prime Line Routing; Engine Shroud Assembly - Toro Power Max Service Manual

Fuel Tank, Fuel Line and Fuel Filter
To remove the fuel tank, unscrew the gas cap, slip the
tank out of the shroud and install the cap. If there is
fuel in the tank, clamp the line, or drain the tank into a
suitable container. Remove the fuel line and fuel fi lter.
The tank is held in place by the bracket and shroud
surrounding it (Fig. 007).
Primer Line Routing
The primer line connects to the back side of the primer
then is routed over the fuel line, over the foam block
(Fig. 008).
Power Max Service Manual
Fig 007
Fig 008
MVC-865XA
It should be gathered and secured to the ignition switch
wires. It then goes down to the primer fi tting on top of the
carburetor (Fig. 009).

Engine Shroud Assembly

MVC-000
1. Ensure the ignition switch is in place and the wire
harness is plugged in, the primer line is attached to
the primer and the primer body is secure in its slot,
and the fuel tank, fuel line and fi lter are properly
installed.
ENGINE
Fig 009
MVC-866XA
3-3