ABB DCS 500B Description page 199

Software for thyristor power converter
Hide thumbs Also See for DCS 500B:
Table of Contents

Advertisement

TC_STATUS
Signal of MAINTENANCE function.
Status of the torque control sequencing:
(internal signal; not shown on the panel; definition)
B0
(RDY ON
B1
(MAIN CONT ON
B2
(RDY RUNNING
B3
(RUNNING
B4
(TC_RDY_REF
B5
(TC_FIELD_CHANGE
B6
(CONTINUOUS_CURR
11204
S: PB
SC: -
BC
Signal of MAINTENANCE function.
Status of the current contoller. If the value of BC is zero, everything is OK. Otherwise
different bits of BC will indicate the reason for blocking the current contoller:
(internal signal; not shown on the panel; definition)
B0
(
B1
(
B2
(
B3
(
B4
(
B5
(
B6
(
B7
(
B8
(
B9
(
B10
(
B12
(
B13
(
B14
(
B15
(
11205
S: PB
SC: -
SQUARE_WAVE
Signal of MAINTENANCE function.
Output of square wave generator. Used for tuning of controllers.
11206
S: I2
SC: -
TEST_REF
Signal of MAINTENANCE function.
Test reference input for different drive functions which are activated with DRIVE_MODE
parameter.
11207
S: I2
SC: 1
TEST_RELEASE
Signal of MAINTENANCE function..
Release-command for a controller in manual tuning of current or EMF controller. In
manual tuning first the reference is selected with the signal TEST_REF_SEL and then the
controller is released by setting TEST_RELEASE to a value different than zero.
11208
S: I2
SC: 1
1 = ready for closing contractor)
1 = command to close contractor)
1 = ready for run command)
1 = command to release controllers)
1 = ready for reference)
1 = field revelsal is active)
1 = armature current is discontinuous)
HL: -
LL: -
overcurrent)
Freewheeling unit was fired)
field reversal)
supply system undervoltage)
12Puls only: fault 65 and 66 occurred)
12Puls only: signal via cable X18)
supply system overvoltage)
type code error)
suppression of controller at contoller change-over)
processor overload)
thyristor diagnostic running)
primary (AC) or secondary (48Vac) power failure)
synchronization signal missing)
pulse firing section not in synchronism)
not released)
HL: -
LL: -
HL: -
LL: -
HL: 32767
LL: -32768
HL: 1
LL: 0
DCS500 Pin and Parameter list
D: -
U: -
D: -
U: -
D: -
U: -
D: 0
U: -
D: 0
U: -
A 95

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents