ABB DCS 500B Description page 198

BACKUPSTOREMODE
Signal of MAINTENANCE function.
BACKUPSTOREMODE is used to give commands to parameter handling function in the
drive:
0 = NONE
1 = SAVE MOT1 SET
2 = SAVE MOT2 SET
3 = FACTORY SET VAL.
4 = SELECT MOT1 SET
5 = SELECT MOT2 SET
6 = READ APPL BLOCKS
activated and saved via SAVE MOTx SET and modified afterwards
without saving the configuration before the last modification (the one
directly after the last SAVE action) can be activated
While the command is executing the value of BACKUPSTOREMODE will show what is
happening or the reason for error if the command fails:
7 = ERASE ERROR
8 = ERASING...
9 = PROGRAM ERROR
10 = PROGRAMMING...
11 = WRONG FLASH TYPE
12 = READING...
13 = READ ERROR
14 = reserved
15 = VERSION ERROR
16 = reserved
17 = SIZE ERROR
11202 S: E2 SC: -
FEXC_STATUS
Signal of MAINTENANCE function.
Status of the field exciters 1 and 2:
(internal signal; not shown on the panel; definition)
B0 (FEXC1_RDY_OPER
B1 (FEXC1_OK
B2 (EXC2_RDY_OPER
B3 (EXC2_OK
B4 (ACK_FEXC1_ON
B5 (ACK_FEXC2_ON
B6 (FIELD_HEAT_ON
B7 (FIELD1_REV_ACK
B8 (ACK_CSC_ON
B9 (ACK_FEXC_ON
B10 (FIELD_REF_ON)
B11 (FIELD1_CURR_MIN_L) 1 = motor 1 field current above min level
B12 (FIELD2_CURR_MIN_L) 1 = motor 2 field current above min level
11203 S: PB SC: -
Save motor set 1
Save motor set 2
Load factory values
Load motor set 1
Load motor set 2
Load application; if additional function blocks are
Error during erasing of parameter flash
Erasing the parameter flash
Error during programing of parameter flash
Programing the parameter flash
Verification error
Reading the parameter flash
Error during reading of parameter flash
Bad type of parameter flash
Bad size of parameter flash
HL: 5 LL: 1
0 = not ready for operation; AC-voltage missing)
0 = self diagnostic failed or power failure in fex 1)
0 = not ready for operation; AC-voltage missing)
0 = self diagnostic failed or power failure in fex 2)
1 = motor 1 field OK)
1 = motor 2 field OK)
1 = motor heating function active)
direction of the field 0 = forward, 1 = reverse)
1 = on-command accepted by sequence control)
1 = motor field OK)
1 = field current reference released
HL: - LL: -
DCS500 Pin and Parameter list
D: - U: -
D: - U: -
A 94