System Board Support Shield Removal - Lexmark X734de Service Manual

System board support shield removal

See
"System board support shield" on page 7-9
Remove the system board. See
1.
Remove the right cover. See
2.
3. Pull the cables through the access holes on the right side of the printer.
Remove the five mounting screws (A) from the outer left side of the printer.
4.
Note: Make a note of the attachment of the printhead ground cable (B) to the fourth screw from the top for
later installation.
Remove the four screws (C) from the inner right side of the support shield.
5.
for the part number.
"System board removal" on page
"Right cover removal" on page
4-165.
4-41.
Repair information
7526
Previous
Next
Go Back
4-171