Wipe Disk; Duplex Gloss - Lexmark X734de Service Manual

Touch Yes.
3.
Warning: To prevent damage to your disk, do not turn the MFP off while the following displays.
Touch Back to return to the main menu.
4.
A graphic appears, showing:
The message Encrypting Disk or Formatting Disk
•
A percentage scale
•
The message DO NOT POWER OFF
•
The process is complete when the percentage scale displays 100.

Wipe Disk

Note: Due to the lengthy amount of time required to wipe an entire hard disk using either method, a wipe should
not be initiated unless it is absolutely unavoidable (for example, disk corruption), or unless the printer can
remain offline for several hours without inconveniencing users.
Warning: A user should not initiate either type of wipe from the Configuration Menu if the hard disk contains
downloaded fonts, macros, held jobs, and so forth that should not be erased.
This setting initiates either a single pass wipe or a multiple pass wipe of the entire hard disk. Select Disk Wipe
(fast) to complete a single pass wipe and replacement of the file system. Select Disk Wipe (secure) to
complete a multiple pass wipe at a more basic level.

Duplex Gloss

If you need higher quality duplex copies, selecting Duplex Gloss give you a higher quality output. It does this by
limiting the number of pages fed at one time. In normal duplex, two sheets are fed simultaneously and one is
printed on page two and the other is printed as page four, then the pages are re-fed and pages one and three
are printed on the other side. With Duplex Gloss turned on, only one page is fed, printed, re-fed and the reverse
is printed. The quality increases, but the time it takes to complete the job is increased.
To turn on Duplex Gloss:
1. Touch Duplex Gloss in the Config Menu.
Touch the left or right arrow to toggle between Off and On.
2.
Touch Submit.
3.
Encrypting Disk
5/7 30%
DO NOT
POWER OFF
7526
Previous
Go Back
Diagnostic aids
3-45
Next