Transfer Module Removal - Lexmark X734de Service Manual

Transfer module removal

See
"Transfer module" on page 7-5
Open the top access cover.
1.
Open the front access door.
2.
3. Disconnect the transfer module cable (A).
Press the two tabs (B) to release the front access cover assembly.
4.
Press the two tabs (C) on either side of the transfer module, and lift out the transfer module.
5.
Note: Leave the photoconductor units on the transport belt when removing.
Warning: To avoid damaging the photoconductor drum, place the transfer module with the
photoconductor units on a clean surface. Never expose the photoconductor units to light for a prolonged
period of time. Place a clean, dry cloth over the transfer module and photoconductor units until they are
required.Lower the front access door cover.
Note: If you are removing the transfer module to access another part, leave the photoconductor units attached,
and you are done. If you need to replace the transport belt, continue with the next step to remove the separate
photoconductor units.
for the part number.
B A C
Repair information
7526
Previous
Next
Go Back
4-191