Font Sharpening; Require Standby; Les Applications; Key Repeat Initial Delay - Lexmark X734de Service Manual

7526

Font Sharpening

Lets a user set a text point-size value below the setting of the high frequency screens used when printing font
data. This menu item only affects the PostScript, PCL, XL, and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high frequency screens. To increase value by 1, touch the right arrow; to decrease the
value by 1, touch the left arrow.
To set Font Sharpening:
Touch Duplex Gloss in the Config Menu.
1.
Touch the left or right arrow to change the value from 1 to 150.
2.
3. Touch Submit.

Require Standby

When set to Off, the Standby Mode setting in General Settings Menu displays Disabled. The default is On.
To set Require Standby:
1. Touch Require Standby in the Config Menu.
Touch the left or right arrow to toggle between On and Off.
2.
Touch Submit.
3.

LES Applications

Enables or disables Lexmark Embedded Solutions (LES) applications. The default is Enable.
To change the setting:
Touch LES Applications in the Config Menu.
1.
Touch the left or right arrow to toggle between Enable and Disable.
2.
Touch Submit.
3.

Key Repeat Initial Delay

Determines the initial length of delay before a repeating key starts repeating. The range is from 0.25 seconds to
5 seconds in 0.25 second increments. The default value is 1 second.
To set the delay:
1. Touch Key Repeat Initial Delay in the Config Menu.
Touch the left or right arrow to change the value from 0.25 second to 5 seconds.
2.
Touch Submit.
3.

Key Repeat Rate

Number of presses per second for a repeating key. The range is from 1 to 100 presses per second. The default
is 15 presses per second.
To set the number of key presses per second:
Touch Key Repeat Rate in the Config Menu.
1.
2. Touch the left or right arrow to change the value from 1 to 100.
Touch Submit.
3.
Service Manual
3-46
Previous
Next
Go Back