Lexmark X734de Service Manual page 49

Error code Action
37 Insufficient memory
to collate job
37 Insufficient memory
for Flash Memory
Defragment operation
37 Insufficient memory,
Some Held Jobs Were
Not Restored
37 Insufficient memory,
Some Held Jobs Will
Not Be Restored
37 Insufficient Defrag There is insufficient memory to perform the Flash Memory Defragment operation. The user
Memory can:
New
38 Memory Full The following options are available:
39 Complex Page The page is too complex to print. Options are:
50 PPDS Font Error
51 Defective Flash
52 Flash Full
• Touch Continue to print the portion of the job already stored and begin collating the rest
of the job.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• Touch Continue to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace the system. See
page 4-165.
• The printer deleted some held jobs in order to process current jobs.
• Touch Continue to clear the message.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
• Touch Continue to clear the message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• Delete font, macros, and other data in memory.
• Install additional printer memory.
• Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• Touch Continue to continue. The job may not print correctly.
• Cancel the job.
• Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• Touch Continue to clear the message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the system board. See
on page 4-165.
• Touch Continue to clear the message and continue printing.
Note: Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the system board. See
on page 4-165.
"System board removal"
"System board removal" on
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal"
Diagnostic information
7526
Previous
Next
Go Back
2-11