Lexmark X734de Service Manual page 66

7526
Error code
243.17
243.26
243.27
243.29
244.02
244.03
Service Manual
2-28
Description
Tray 3 detected a jam from idle.
Possible causes:
• Paper jam leaving page over
sensor
• Defective input sensor
• Faulty system card
While feeding from a lower tray, tray 3
pass thru sensor is not made.
Possible causes:
• Incorrect paper loading for lower
tray
• Incorrect media restraint setting
for lower tray
• Paper tray 3 assembly failure
• Lower tray 4 assembly failure
While feeding from a lower tray, tray 3
pass thru sensor did not break.
Possible cause is a paper tray 3
assembly failure
Tray 3 is not ready while printing.
Possible cause is paper tray 3
assembly failure.
Tray 4 pass thru sensor made at
POR.
Possible causes:
• Paper jam leaving page over the
sensor
• defective pass thru sensor
Pick timeout from tray 4 was
exceeded without a tray 4 sensor
break.
Possible causes:
• Tray 4 incorrect media setting
• Tray 4 incorrect paper loading
• Tray 4 incorrect media restraint
setting
• Tray 4 assembly failure
• Aligner failure
• Transport belt module failure
Action
• Clear away anything in the paper path that might
cause the media to jam.
• If the problem persists, go to
Jam service check" on page
• Clear away anything in the paper path that might
cause the media to jam.
• Make sure proper media is set for the type of
paper used in lower feeding tray.
• Fan media, and stack flat in the lower feeding
tray.
• Properly set media restraints in the lower
feeding tray.
• Check the pick tires in lower tray and replace if
worn.
• If the problem persists, go to
Jam service check" on page
• Clear away anything in the paper path that might
cause the paper to jam.
• Reseat option tray 3
• If the problem persists, go to
Jam service check" on page
• Make sure that tray 3 is correctly inserted.
• If the problem persists, go to
Jam service check" on page
• Check for anything in the paper path that might
cause the paper to jam.
• If the problem persists, go to
Jam service check" on page
• Remove all media present in the paper path.
• Maker sure proper media is set for the type of
paper used in tray 4.
• Fan the media, and stack flat in tray 4.
• Properly set media restraints in tray 4.
• If the problem persists, go to
Paper Jam service check" on page
Previous
"243.17—Paper
2-82.
"243.26—Paper
2-83.
"243.27—Paper
2-83.
"243.29—Paper
2-83.
"244.02—Paper
2-84.
"244.03, 244.11—
2-85.
Next
Go Back