Danfoss VLT Decentral Drive FCD 302 Operating Manual page 67

Troubleshooting
No. Description
77 Reduced power mode
78 Tracking Error
79 Illegal PS config
80 Drive Initialized to Default Value
81 CSIV corrupt
82 CSIV parameter error
85 Profibus/Profisafe Error
90 Feedback Monitor
91 Analogue input 54 wrong settings
250 New spare part
251 New Type Code
Table 7.1 Alarm/Warning Code List
(X) Dependent on parameter
A trip is the action performed when an alarm arises. The trip causes the motor to coast. Reset the trip by pressing [Reset],
or perform a reset via a digital input (parameter group 5-1* [1]). Trip is used when the original event causing the alarm
cannot damage the frequency converter or cause dangerous conditions. A trip lock is the action performed when an alarm
occurs, which can cause damage to the frequency converter or connected parts. A trip lock situation can only be reset by a
power cycling.
LED Indication
Warning
Alarm
Trip locked
Table 7.2 LED Indicator Status
MG04F402
Operating Guide
Warning Alarm/Trip
X
(X) (X)
X
X
X
X
X
(X) (X)
X
1) Can not be Auto reset via parameter 14-20 Reset Mode
yellow
flashing red
yellow and red
Danfoss A/S © 05/2016 All rights reserved.
Alarm/Trip Lock Parameter Reference
Parameter 14-59 Actual Number of Inverter
Parameter 4-34 Tracking Error Function
X
Parameter 17-61 Feedback Signal
X
X Parameter 14-23 Typecode Setting
X
Units
Monitoring
S202
65
7 7