Nat Exclude Ip - DCP -WR300N User Manual

Field
3.5.2.3 ALG
Click ALG in the left pane, the page shown in the following figure appears.
Choose the NAT ALG and Pass-Through options, and then click Apply
Changes.

3.5.2.4 NAT Exclude IP

Click NAT Exclude IP in the left pane, the page shown in the following figure
appears.
In the page, you can configure some source IP addresses which use the purge
route mode when accessing internet through the specified interface.
Configuration
Description
same network segment with LAN IP address of the
router.
48 DCP-WR300N