3.5 Advanced
In the navigation bar, click Advanced. The tab Advanced contains Route, NAT,
QoS, CWMP, Port Mapping and Others.
3.5.1 Route
Choose Advanced > Route, the page shown in the following figure appears. The
page that is displayed contains Static Route, RIP.
3.5.1.1 Static Route
Click Static Route in the left pane, the page shown in the following figure
appears. This page is used to configure the routing information. You can add or
delete IP routes.
The following table describes the parameters and buttons of this page.
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Configuration
Description
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the
destination device.
The metric cost for the destination.
42
DCP-WR300N
Need help?
Do you have a question about the DCP-WR300N and is the answer not in the manual?