Adjust Offset (Redox/Orp Only) - ABB AX416 User Manual

Single and Dual Input Analyzers for pH/Redox (ORP)
AX416, AX436, AX460, AX466 & AX468

4.1.3 Adjust Offset (Redox/ORP Only)

-----
Sensor Cal. A
mV
0
mV
407
A: Adjust Offset
Sensor Cal. A
22
Calibrate Sensor A
Sensor B (dual input analyzers only) calibration is identical to Sensor A calibration.
Sensor Cal. B
for Sensor B (dual input analyzers only) set to
Probe Type
SENSOR CAL.
set to
Cals. No
SECURITY CODE
Alter Sec. Code
CONFIG. DISPLAY
Alter Sec. Code
set to
A: Adjust Offset Probe Type
set to
A: Buffer Method Probe Type
Adjust Offset (ORP/Redox probes only)
and
mV Adjust
keys to adjust the upper display line to the required offset value for the process.
Sensor Cal. B
Sensor B (dual input analyzers only) calibration is identical to Sensor A calibration.
for Sensor B (dual input analyzers only) set to
SENSOR CAL. Probe Type
set to
Cals. No
SECURITY CODE
Alter Sec. Code
CONFIG. DISPLAY
Alter Sec. Code
(Section 5.3) - return to top of page.
not set to zero (Section 5.8) - see section 5.1, page 28.
set to zero (Section 5.8) - see section 5.2, page 29.
or (Section 5.3) - continued below.
Redox ORP
(Section 5.3) - see section 4.1.1, page 19.
pH
are shown alternately on the upper display line. Use the
(Section 5.3) - return to top of page.
not set to zero (Section 5.8) - see section 5.1, page 28.
set to zero (Section 5.8) - see section 5.2, page 29.
4 SETUP
or and
Redox ORP Enable
and
or and
Redox ORP Enable
IM/AX4PH Issue 9