Mode Select Memory Scan; Dsetting The Receive Mode; Setting The Skip Frequency; Dsetting The Skip Frequency - Icom IC-R8600 Instruction Manual

9
SCANS

Mode select memory scan

(Example) Group: ALL (Each channel is in the different group.)
WFM AM
00ch 01ch
All modes except the
WFM 99ch
WFM are skipped.
98ch 50ch
WFM AM
Repeatedly scans the selected receive mode (ignoring
other modes) while memory scanning, except
Programed Scan Edge channels
.
P49B)
D Setting the receive mode
1. Select the receive mode.
2. Open the SCAN screen.
» SCAN
MENU
3. Touch [TYPE/SET].
SCAN screen
4. Touch [MODE].
5. Touch [SELECT] to select the item, then rotate
to change the setting.
• Set the channel group and edge channels.
LYou cannot change the receive mode on this screen.
6. Touch [SELECT] several times to exit the edit
mode, then touch [START].
• The mode select memory scan starts.
L "MODE SELECT MEMORY SCAN" and decimal
points blink while scanning.
• Touch [STOP] to cancel the scan.
7. To close the SCAN screen, push
WFM WFM
02ch 03ch
WFM
04ch
06ch 05ch
AM WFM
(P00A/P49A ~ P00B/
Blinks
Deactivated
during a Memory
scan
.
EXIT

Setting the skip frequency

You can set a frequency as a skip frequency that is
skipped (ignored) during a VFO scan*.
* Programmed scan, Fine Programmed scan, Auto Write Memory
scan, ∂F scan and Fine ∂F scan
D Setting the skip frequency
z Hold down
received and the scan is paused.
• The frequency is stored as the Scan Skip channel (S00
~ S99).
L The "PSKIP (Program SKIP)" is displayed on the skip
channel.
LDuring a VFO scan, the skip frequency is not skipped.
D Canceling the skip frequency
1. Touch the memory channel number.
2. Touch [SKIP].
L Each touch changes between "SKIP," "PSKIP" and
"(no icon)."
VFO/MEMORY screen
L"PSKIP" disappears and the skip setting is cancelled.
3. To close the VFO/MEMORY screen, push
9-9
for 1 second while a signal is
.
EXIT