Event; Alarm - EverFocus EMV800 HD User Manual

EMV800 HD / EMV1200 HD Mobile DVR
7.3.3

Event

You can configure the Alarm, Video Loss, Motion and Other settings in this menu.

7.3.3.1 Alarm

SD Backup
Alarm: Select an Alarm input number from 1 to 16.
Enable: Check the box to enable the Alarm trigger function for the selected alarm input.
Log: Check the box to record alarm events to log data.
Pre-alarm Record: Check the box to start copying the recordings to the hard disk from 5
seconds before the alarm event occurs. Note that the pre-alarm recording rate will follow the
Normal Speed configured in the earlier section (see 7.3.1.1 Basic Setting).
Buzzer: Check the box to enable the buzzer when an alarm event is triggered.
Email Notify: Check the box to send email notification with a snapshot file when an alarm
event is detected. Email operation requires valid email entered in the Email setup menu (see
7.3.6.4 Email).
Network Alarm: Check the box to send out a network alarm to a client PC when an alarm
event occurs. This feature works with EverFocus' CMS software. You will need to configure
the Alarm Server for the mobile DVR to send network alarms to the client PC (see 7.3.6.7
Alarm Server).
Auto Lock: Check the box and the events will be recorded in a write protected segment of the
hard disk (will not be overwritten). The mobile DVR will lock a period of time when the alarm
occurs. The length of the time depends on mobile DVR setting (see 7.3.4.2 Lock / Format).
SD Backup: Check the box to enable Alarm event backup recordings to the SD card. When an
alarm is triggered, the mobile DVR will record the alarm event to the SD card for 60 seconds
start from the triggered time. The SD card will start recording the next alarm event only when
152