2. Wi-Fi Module Installation 1. Open the cover of the mobile DVR by unscrewing below screws. 1 big screw on the Rear Panel 2 small screws 2 small screws on the Left Side on the Right Side 2 small screws on the Top Cover Small screw...
2. Overview: To install a Wi-Fi Module, you need to install the packaged items to the Daughter Board on the Mobile DVR. Mobile DVR: Daughter Board Daughter Board: Wi-Fi USB Socket Screw the Wi-Fi Module Here...
Page 5
3. Plug the Wire Cable to the Wi-Fi Module. Wire Cable Wi-Fi Module 4. Screw the Wi-Fi Module to the Daughter Board using the supplied screws.
Page 6
5. Plug the other end of the Wire Cable to the Wi-Fi USB Socket. Wi-Fi USB Socket Wire Cable 6. Plug the RF Cable Assembly to the small circle on the Wi-Fi Module. RF Cable Assembly...
Page 7
7. Remove the Ant. 4 plug in order to insert the RF Cable Assembly for connecting the Wi-Fi antenna. 8. Insert the RF Cable Assembly through the Wi-Fi antenna hole (Ant. 4). Please remember to use the Outer Ring and the Hexagon Nut to tighten the connector as the figure below.
Page 8
9. Screw the Wi-Fi Antenna to the Ant. 4 connector. 10. Screw back the cover of the mobile DVR to complete the Wi-Fi Module and Antenna Installation.
Page 9
Ihr EverFocus Produkt wurde entwickelt Your EverFocus product is designed and und hergestellt mit qualitativ hochwertigen manufactured with high quality materials Materialien und Komponenten, die and components which can be recycled recycelt und wieder verwendet werden and reused.