EverFocus EMV800 HD User Manual page 200

Schedule setting
1. Select a camera first and click on desired start time block on a time bar. At this time, the
entire time bar will be highlighted with a red frame.
2. Double-click the desired start time block, and this block (shows a new sequence number
on it) and all the following blocks will turn to gray. This means the grey time blocks has
been set to No Recording mode.
3. To change the time blocks to different recording mode (which shows a different color),
users need to double-click on the block (with number on it) of any section. Every time the
user double-clicks the first block of a section, the color switches from gray->pink ->blue-
green.
4. Repeat the above steps to configure the recording modes. You can configure up to six
record modes on each time bar.
Click the "Edit Timezone" button to edit the recording parameters for a time zone.
Editing Timezone:
From: Displays time zone start time.
To: Displays time zone end time.
Record: Displays Record mode.
Resolution: Recording resolution is displayed.
Normal: Frame rate in FPS for continuous recording. It is important to keep track of the
normal recording resources being allocated at each hours of the day. Increasing the Normal
recording resolution and/or rate can inadvertently request more recording resources than the
mobile DVR is capable of delivering, or allocate so much of the mobile DVRs resources that
there is no excess available for increased FPS rate and/or resolution in response to an Event.
The speed is limited by the maximum total recording capacity of the mobile DVR as allocated
across TV standard in global setting, all the installed cameras, with an upper limit of 30 FPS
(NTSC – 25 PAL) per individual camera (real time recording).
Since EverFocus mobile DVRs have the capability to change the FPS rate in response to events,
it may be advisable to reserve some recording capacity for event response.
EMV800 HD / EMV1200 HD Mobile DVR
190