Drum Cleaning - Mita DP-2800 Service Manual

5A2

Drum cleaning

This mode is meant to provide a manual means of drum cleaning in addition to the regular
cleaning procedure made automatically in a photographic cycle. In this mode, the drum
turns for the period of approximately three minutes with no main charging dispersed over
the drum. Since the cleaning blade in the drum continuously attempt to scrape soils and
paper dust on its surface, the drum can be brought in a clean state.
To clean the drum using this feature, perform the following, top to bottom:
press MODE
press repeatedly until:
press
press repeatedly until:
press , the display should show:
press , the display should show:
press ENTER, the display should show:
press ENTER
The drum then starts turning and stops after approx. 3 minutes. The printer reverts to Ready.
6-40
then,
Others>
then,
>Service>
>>Developer
>>Drum
?