General Instructions - Mita DP-2800 Service Manual

General Instructions

This chapter provides procedures for removal and replacement of field replacement
components. For other components not shown in this chapter, the diagrams in the Parts List
attached with this handbook will help locate the component.
For replacement of a component, use the reverse of the removal procedures explained in
this chapter.
Before proceeding, make sure printer power is switched off and the power cord is unplugged
from the printer. See Warning below.
Warning: To avoid injury to human bodies, make sure that AC power is removed and the
power cord is unplugged from both the power line and the printer.
Caution: To secure a self-tapping screws, align it with the thread carefully. First turn it
counterclockwise, then slowly clockwise. Do not over-tighten. In case the
selftapped thread is damaged, the affected part must be replaced with a new
part.
5A2
5-1