Installing A New Developer - Mita DP-2800 Service Manual

5A2

Installing a new developer

To install a new developer, use the reverse manner as above. Note that the new developer
is shipped from the factory with a protective cover 1 installed. Leave the protective cover
installed with the developer until the developer has been installed in the printer.
When the developer has been installed in the printer, grasp and pull the protective cover all
the way out, as shown below. Latch in the developer release lever.
Caution: Push in the developer unit slow and gently. If the developer contains toner,
pushing in the developer unit rudely can cause the distribution of toner to become
uneven in the far side of the developer. Also, it may risk damaging the connector
at the far end of the developer (and the mating connector in the printer).
3-10
1