Feeding Toner Into The New Developer - Mita DP-2800 Service Manual

Feeding toner into the new developer

The new developer unit is shipped from the factory with no toner contained. The developer
can be automatically replenished with toner when a toner container is installed onto it and
the printer is turned on. However, because the toner reservoir in the developer has a large
capacity, it requires a lengthy period of time until a substantial amount of toner has been fed
to get the printer ready.
A great many seconds of time for this is greatly deducted by using the service menu in the
printer's mode select routine as accessed by its front control panel. Follow these steps to
use this feature, top to bottom. (For details on using the front control panel keys, refer to the
printer's instruction handbook.)
Key to press:
MODE
(repeatedly)
(repeatedly)
ENTER
ENTER
When printer power is turned on again, the printer continually engages in this mode for
several minutes after which the printer reverts to the ready state.
Relevant display:
Others>
>Service>
>>Developer
>>Developer?
Turn printer power off, then on.
5A2
3-11