Toner Container Replacement; Toner Saver Mode ( Ecoprint ) - Mita DP-2800 Service Manual

Toner container replacement

To replace the toner container, open the top cover 1. Pull the toner container release levers
2 to the right position as shown. Lift and pull out the toner container 3.
2
Then, refer to section Installing toner in chapter 2 to install the new toner container. After
installing the new toner container, several parts in the printer must be cleaned as instructed
in section Cleaning the printer on page Chapter 3-4.
If the toner container has been replaced when the message
Replace Toner ... Clean printer
was displayed, then, the message
Clean printer ... press CONTINUE
will be displayed after replacement. After cleaning the inside of the printer following the
procedure shown below, press the CONTINUE key; the message will disappear and the
printer will be ready for printing.

Toner saver mode ( EcoPrint )

The EcoPrint enables to reduce the amount of toner consumed on the page so as to save
printing costs by drastically extending the toner container life. EcoPrint mode is factory-set
to off and turned on by the printer's front control panel (also accessible through the
application software with the assistance of the printer driver). See details in the printer's
instruction handbook.
5A2
1
3
3-3