Removing The Drum Unit - Mita DP-2800 Service Manual

Removing the drum unit

Caution: Removing or reinstalling the drum unit requires the drum protective cover
supplied with the new drum kit package. Do not forcibly attempt to remove the
drum without following the procedures provided below, using the drum protective
cover.
Caution: Store the drum unit in a clear, clean place, not exposed to a strong light source.
Seal it in a protective bag. Avoid bump the drum surface onto hard objects.
To remove the drum unit 1, first insert the drum unit protective cover 2 as shown below.
This unlatches the drum unit for removal. Be sure to install the protective cover firmly in.
While pressing the drum release lever 3 at the left side of the printer, as shown below, pull
the drum unit all the way out. It should come off with the protective cover. When the drum
unit is halfway out, hold the handle at the top of the drum unit.
3
5A2
1
2
5-9