Mita DP-2800 Service Manual page 128

5A2
Message
Print overrun
Press CONTINUE
MEMORY CARD err
Insert again
Insert the same
MEMORY CARD
Warning battery
MEMORY CARD
Battery error
MEMORY CARD
Format error
MEMORY CARD
MEMORYCARD err ##
Press CONTINUE
6-10
Current print processing cannot continue due to insufficient
memory. The data transferred to the printer was too complex
to print on a page.
Check available user memory by printing a status page, and
either remove unnecessary download fonts and/or macros or
expand the printer's memory.
Note: After this message has been displayed, Page protect
mode will be on. To maintain optimum use of memory
during printing, display >Page protect from the mode
select menu, and re-select Auto.
Press the CONTINUE key to print data as far as it was stored.
You can abandon printing by the CANCEL key.
The memory card is missing. This message appears when
the memory card has been removed from the memory card
slot during memory card operations. Re-insert the same
memory card in the same slot. the printer will continue with
memory card processing.
Insert the same memory card. This message appears when
the memory card has been removed from the memory card slot
during memory card operations and replaced with a different
memory card. Re-insert the same memory card in the same
slot. the printer will continue with memory card processing.
The memory card's battery is low. This message appears
when the printer is in the ready state and the battery of the
memory card installed in the printer is low. You can still enter
the memory card mode, but the battery should be changed as
soon as possible.
Insert a new battery in the memory card. This message
appears when the printer is in the ready state and the battery
in the memory card is missing or completely dead. Memory
card operations are not possible. Insert a new battery in the
memory card.
The memory card requires formatting. This message appears
when the printer is in the ready state and the memory card is
not formatted. Be sure to format the memory card. (See the
instruction handbook.)
This message appears when an error occurs during access
to the memory card using the PRESCRIBE ICCD command
or from the printer's control panel. Look at the error code
given in place of ## and refer to the corresponding description
given below. Note that only error codes 09 and 11 are
displayed due to memory card operations made from the
control panel.
For details, see Memory card errors which follows on page
Chapter 6-11.
Corrective action