Downloading Engine Firmware Data; Downloading Controller Firmware Data - Mita DP-2800 Service Manual

Downloading engine firmware data

To download engine firmware or panel message data, use Prescribe BOOT command.
Perform in sequence:
Turn printer power on. Make sure the printer is Ready .
At the DOS prompt, send the following command to the
printer.
!R! BOOT "SPR";
Note: Do not add an EXIT; command in the above.
The display indicates Supervisor mode when the
above command is sent to the printer.
DOS COPY (/b) the data to download from the host
computer. The display shows Downloading while
downloading data.
When downloading finishes, the display reverts to
Supervisor mode. In this state, turn power off.
Turn power on again. Check the display shows Ready.
Caution: Do not turn off printer power while data are being downloaded (approximately
one minute).
Confirm the status page shows the new engine version. If the message display indicates
Call service person Dn ( n =0, 1, ...) , refer to section Errors during downloading on page
Chapter 3-14.

Downloading controller firmware data

To download controller firmware data, use Prescribe UPGR command as follows.
Perform in sequence:
Turn printer power on. Make sure the printer is Ready .
At the DOS prompt, send the following command to the
printer:
!R! UPGR "SYS";
Note: Do not add an EXIT; command in the above.
The display should indicate Supervisor Mode when the
above command is sent to the printer.
DOS COPY (/b) the data to download from the host
computer. The display shows Downloading while
downloading data.
Relevant display
Ready
Supervisor mode
Downloading
Supervisor mode
Ready
Relevant display
Ready
Supervisor mode
Downloading
5A2
3-13