Places To Avoid; Note On Power - Mita DP-2800 Service Manual

5A2

Places to avoid

Avoid installing the printer in locations exposed to:
• Direct drafts of hot or cold air.
• Direct drafts of outside air. (Avoid locations next to outside doors.)
• Sudden temperature or humidity changes.
• Any source of high heat, such as a radiator or stove.
• Excessive dust. Dust and smoke may cause contamination on the laser scanner window,
causing print quality problem.
• Vibration.
• Ammonia fumes or other harmful fumes. (In case of humigating the room or saturate it with
insecticide, remove the printer first.)
• Avoid greenhouse-like rooms. (Because of sunlight and humidity.)
• Avoid enclosed spaces that block ventilation.
• Avoid sites more than 6500 feet or 2000 meters above sea level.

Note on power

Use only the power source voltage conforming to the printer's rated power voltage. Do not
use other power sources.
• Disconnect the printer from the power source before attempting removal or re-placement
of an electrical component or a printed-circuit board.
• The printer should not be connected to a power source until the instruction is given to do
so when performing tests described in this handbook.
• In connecting the printer power, exercise an extreme care in handling the power supply
or any other electric parts which may give an electric shock.
• Before performing maintenance or repair, power from both the power source and the
associated peripheral devices (computer, sorter, etc.) should be disconnected, unless
otherwise specified.
• To avoid possible electrical shock, extreme caution must be exercised in handling the
power cord and any other electrical part.
• An easily accessible socket outlet must be provided near the equipment.
1-10