TESTO 330 Instruction Manual page 53

d Quality Products Online at:
> [Options] → Configure
parameters to be represented (max. 4) can be displayed (
hidden ( ).
[Options] Draught measure
> →
view is opened and a draught measurement can be carried out.
> [Options] → Flue Gas
flue gas matrix, see below.
> [Options] → Number of
measuring values per display page.
> [Options] → Accept measuring values from 315-3:
Ambient CO/CO2 values measured with the testo 315-3 can be
accepted by the testo 330. Data is transferred via Bluetooth® or
via the IrDA interface.
For data transfer via Bluetooth®, the testo 315 - 3 and the
testo 330 - 2 must have this option, otherwise data is
transferred via the IrDA interface.
✓ A measurement was carried out with the testo 315-3.
✓ testo 330-2 is on.
✓ Data transfer at the testo 315-3 has been enabled.
- The testo 330 accepts the instrument-specific information
and measurement data sent from the testo 315-3. The
measurement data is displayed under ppm AmbCO or ppm
AmbCO2.
[Options] → Recalibrate: The gas sensors are set to zero.
>
> [Options] → Measurement
during a measurement): The readings display menu is opened.
Show flue gas matrix
This function is only available if the measurement parameter
has been activated in the readings display.
Calling up the function:
✓ The flue gas function is opened.
> [Options] → Flue Gas
Options
> [Options] → Clipboard: Data are saved to the clipboard:
> [Options] → Delete
is deleted.
> [Options] → Save: The readings are saved in a record.
GlobalTestSupply
www.
Graphic: The measurement
start/stop: The measurement
Matrix: The readings are displayed as
Lines: Change the number of
view: (This function is not available
Matrix:
clipboard: Any data saved to the clipboard
.com
6 Using the product
) or
CO
53
sales@GlobalTestSupply.c