Appendix B
Catalyst 3750 Switch Debug Commands
Usage Guidelines
The undebug platform ip multicast command is the same as the no debug platform ip multicast
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
Command
show debugging
OL-8552-07
Description
Displays information about the types of debugging that are enabled.
debug platform ip multicast
Catalyst 3750 Switch Command Reference
B-53