Debug Platform Dot1X - Cisco catalyst 3750 Command Reference Manual

debug platform dot1x

debug platform dot1x
Use the debug platform dot1x privileged EXEC command to enable debugging of stack-related
IEEE 802.1x events. Use the no form of this command to disable debugging.
Syntax Description
initialization
interface-configuration
rpc
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-42
debug platform dot1x {initialization | interface-configuration | rpc}
no debug platform dot1x {initialization | interface-configuration | rpc}
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Display IEEE 802.1x-authentication initialization sequence debug
messages.
Display IEEE 802.1x interface configuration-related debug messages.
Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
Appendix B Catalyst 3750 Switch Debug Commands
OL-8552-07