Debug Platform Vlan - Cisco catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform vlan

Use the debug platform vlan privileged EXEC command to enable debugging of the VLAN manager
software. Use the no form of this command to disable debugging.
Syntax Description
errors
mvid
rpc
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform vlan command is the same as the no debug platform vlan command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-8552-07
debug platform vlan {errors | mvid | rpc}
no debug platform vlan {errors | mvid | rpc}
Display VLAN error debug messages.
Display mapped VLAN ID allocations and free debug messages.
Display remote procedure call (RPC) debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750 Switch Command Reference
debug platform vlan
B-81