Cisco catalyst 3750 Command Reference Manual page 1050

debug platform tcam
l3 {acl {input | output} |
ipv6 {acl {input | output} |
local | qos | secondary} |
local | qos | secondary}
read {reg | ssram | tcam}
search
write {forw-ram | reg |
tcam}
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform tcam command is the same as the no debug platform tcam command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Catalyst 3750 Switch Command Reference
B-78
Display Layer 3 field-based CAM look-up type debug messages. The
keywords have these meanings:
acl {input | output}—Display input or output ACL look-up debug
•
messages.
ipv6 {acl {input | output} | local | qos | secondary}—Display
•
IPv6-based look-up debug messages. Options include displaying
input or output ACL look-up, local forwarding look-up,
classification and QoS look-up, or secondary forwarding look-up
debug messages.
local—Display local forwarding look-up debug messages.
•
qos—Display classification and quality of service (QoS) look-up
•
debug messages.
secondary—Display secondary forwarding look-up debug
•
messages.
Display TCAM-read debug messages. The keywords have these
meanings:
reg—Display TCAM-register read debug messages.
•
ssram—Display synchronous static RAM (SSRAM)-read debug
•
messages.
tcam—Display TCAM-read debug messages.
•
Display supervisor-initiated TCAM-search results debug messages.
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Modification
This command was introduced.
Appendix B Catalyst 3750 Switch Debug Commands
OL-8552-07