Debug Platform Wireless-Controller - Cisco catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform wireless-controller

Use the debug platform wireless-controller privileged EXEC command to enable debugging of the
internal wireless LAN controller on a Catalyst 3750G Integrated Wireless LAN Controller Switch. Use
the no form of this command to disable debugging.
Syntax Description
all
packets
session
sm
wcp
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(25)FZ
Usage Guidelines
The undebug platform wireless-controller command is the same as the no debug platform
wireless-controller command.
This command applies only to the Catalyst 3750G Wireless LAN Controller Switch.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show platform
wireless-controller
OL-8552-07
debug platform wireless-controller {all | packets | session | sm | wcp}
no debug platform wireless-controller {all | packets | session | sm | wcp}
Display all wireless controller debug messages.
Display Wireless LAN Control Protocol (WCP) packet debug messages.
Display wireless controller session debug messages.
Display wireless controller state machine debug messages.
Display all WCP debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays information about the internal wireless controller.
debug platform wireless-controller
Catalyst 3750 Switch Command Reference
B-107