Debug Platform Frontend-Controller - Cisco catalyst 3750 Command Reference Manual

debug platform frontend-controller

debug platform frontend-controller
Use the debug platform frontend-controller privileged EXEC command to enable debugging of
front-end controller activity. Use the no form of this command to disable debugging.
Syntax Description
all
image
led
manager
poe
register
thermal
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(20)SE3
Usage Guidelines This command is only supported on Power over Ethernet switches.
The undebug platform frontend-controller command is the same as the no debug platform
frontend-controller command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, start a session from the stack master by using the session switch-number privileged EXEC
command. Then enter the debug command at the command-line prompt of the stack member. You can
also use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Catalyst 3750 Switch Command Reference
B-46
debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
no debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
Display all the debug messages for front-end controller.
Display Image Manager debug messages.
Display LED debug messages.
Display front-end-controller manager debug messages.
Display Power over Ethernet (PoE) debug messages.
Display Register Access debug messages.
Display thermal debug messages.
Modification
This command was introduced.
Appendix B Catalyst 3750 Switch Debug Commands
OL-8552-07