Debug Platform Ip Dhcp - Cisco catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform ip dhcp

Use the debug platform ip dhcp privileged EXEC command to debug DHCP events. Use the no form
of this command to disable debugging.
Syntax Description
all
error
event
packet
rpc
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(19)EA1
Usage Guidelines
The undebug platform ip dhcp command is the same as the no debug platform ip dhcp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show ip dhcp snooping
show ip dhcp snooping
binding
show debugging
OL-8552-07
debug platform ip dhcp [all | error | event | packet | rpc]
no debug platform ip dhcp [all | error | event | packet | rpc]
(Optional) Display all DHCP debug messages.
(Optional) Display DHCP error debug messages.
(Optional) Display DHCP event debug messages.
(Optional) Display DHCP packet-related debug messages.
(Optional) Display DHCP remote procedure call (RPC) request debug
messages.
Modification
This command was introduced.
Description
Displays the DHCP snooping configuration.
Displays the DHCP snooping binding information.
Displays information about the types of debugging that are enabled.
debug platform ip dhcp
Catalyst 3750 Switch Command Reference
B-49