Equipping The Basic System; Interface Card - Aastra Ascotel IntelliGate 150 System Manual

4. 5

Equipping the Basic System

For an individual expansion the A150/300 basic system is equipped with interface
cards, the appropriate wiring adapters and system modules. An overview can be
found in the Chapter
4. 5. 1

Interface card

Interface cards are fitted to slots IC1...IC4. IC3 and IC4 are to be found only on the
A300 (see Fig. 8).
Disconnect the system from the power supply.
1.
Warning
Be sure to observe the
Remove the housing cover.
2.
Place the interface card at a slight angle into the required slot (see
3.
sure the angled side of the interface card is facing backwards (i.e. it must not
project over the wiring adapter slots).
Carefully press the interface card downwards until the two lateral metal clamps
4.
engage.
Fit the corresponding wiring adapter (see
5.
propriate wiring adapter slot WA1...WA4.
Fit the housing cover.
6.
Reconnect the system to the power supply.
7.
Fig. 27 Fitting an interface card
Installation
Ascotel® IntelliGate® 150/300 as of I7.9
"Expansion Stages and System Limits", page
"Safety regulations", page
1
61.
"Wiring Adapter", page
23.
Fig. 27). Make
78) into the ap-
2
77