Aastra Ascotel IntelliGate 150 System Manual page 204

Ascotel® IntelliGate® 150/300 as of I7.9
PC format
The event signal format "PC" is required if a PC is configured as the local signal des-
tination using the System Event Manager (SEM).
Configuring a local signal destination on an S interface / ISDN
As with an external signal destination the event message opens a PPP communica-
tion channel from the PBX to a Terminal Adapter, connected either directly to a PC
with the System Event Manager (SEM) or indirectly via a LAN (ISDN gateway). Once
the event has been confirmed, the PBX clears down the PPP connection.
Configuring a local signal destination on an S interface
The event messages are displayed in PC format.
The "Local Output
nance Manager.
The following parameters need to be selected or entered in the Fault & Mainte-
nance Manager:
• Destination: "Local
• Call number of the local signal destination (the call number is checked by the
PBX, a warning message will appear if the call number is incorrect)
• IP address of the PC if the PBX is to connect with the PC via an ISDN gateway.
If the PBX is to connect with the PC without ISDN gateway, the
should remain empty.
• TCP port number (the initialization value is 1062; if the value is changed in the
SEM, it will have to be altered accordingly on the PBX side.)
• User name and password of the dial-up networking of the PC or ISDN gateway,
to gain access via the TA or the ISDN gateway to the PC with the SEM.
Configuring a local signal destination on ISDN
The event messages are displayed in PC format.
The "Local Output
nance Manager.
The following parameters need to be selected or entered in the Fault & Mainte-
nance Manager:
• Destination: PPP via ISDN communication protocol
204
Interface" must be set on
PPP" communication protocol.
Interface" must be set on
"IP Destination" in the Fault & Mainte-
"IP Destination" in the Fault & Mainte-
Operation and Maintenance
"IP address" entry