Aastra Ascotel IntelliGate 150 System Manual page 203

Note:
Event tables and signal destinations should be set in such a way that the
event message
immediately to any signal destination still available.
Configuring a local signal destination on a V.24 interface
The local signal destination is connected to the V.24 interface of a Pocket Adapter
(PA).
The "Local Output
Manager.
The following parameters need to be selected or entered in the Fault & Mainte-
nance Manager:
• Location of the V.24 interface to which the local output destination is connected
(V.24 PA = Pocket Adapter)
• Required output format "PC" or "Printer" (see
• With "Printer" output format: Language in which the event messages are to be
output.
• With the V.24 interface on the PA - port address
• With "PC" and "Printer" output format as the output location: Maximum page
length of the printout
Output formats
There are two output formats available for local signal destinations connected to a
V.24 interface.
• Printer Format
• PC format
Printer Format
11.03.97 10:12 LOSS OF SYNC ON T/T2 O.9
haz1234aaena0
Fig. 81 Event signal format "Printer" for printer as the local output destination (example with date,
time and event message)
Operation and Maintenance
Internal event message destination
Interface" must be set on "Printer" in the Fault & Maintenance
11.03.97 10:12 LOSS OF SYNC ON T/T2 O.9
haz1234aaena0
Ascotel® IntelliGate® 150/300 as of I7.9
"Output formats", page
missing" is signalled
203)
203