Installing The Fan - Aastra Ascotel IntelliGate 150 System Manual

4. 2. 7. 2

Installing the fan

Materials required:
• Fan from rack-mounting set A300
• 2 screws from the rack-mounting screw set A300
• Screwdriver
To install the fan proceed as follows:
Disconnect the system from the power supply.
1.
Warning
Be sure to observe the
Remove the housing cover.
2.
Use the two screws to fit the fan to the inside of the housing. Take note of the ar-
3.
rows on the fan. They indicate the direction of rotation and the air flow. The air
must flow out of the housing of the basic system (see
Plug the fan connector into the socket marked "FAN" on the mainboard.
4.
Fit the housing cover.
5.
Reconnect the system to the power supply.
6.
Note
The fan only turns if required by the equipment temperature.
Fig. 21 Installing the fan in A300
Installation
Ascotel® IntelliGate® 150/300 as of I7.9
"Safety regulations", page 61.
Fig. 21).
69