Configuration Steps; System Initialization; Hardware-Induced Initialization; Software-Induced Initialization - Aastra Ascotel IntelliGate 150 System Manual

Ascotel® IntelliGate® 150/300 as of I7.9
5. 6

Configuration Steps

The configuration steps are based on the information determined during the plan-
ning and, where applicable, the installation.
5. 6. 1

System initialization

If a system is to be upgraded, it must first be in a defined state. This involves setting
or deleting all the parameter values to their initialization value and carrying out a
self-test.
This initialization can be achieved in the following ways:
• With the pilot key on the front panel
• With AIMS
5. 6. 1. 1

Hardware-induced initialization

See "Carrying out a first start", page 186
5. 6. 1. 2

Software-induced initialization

Carry out an initialization in the AIMS Configuration Manager or in the Fault and
Maintenance Manager under "Online" → "
be modified, create a new PBX in the AIMS Shell and select a sales channel. Then
under "Tools" →
"Set/Change Sales
responding initialization values.
Note:
To perform a first-start or a sales channel change, either a user account
with the corresponding authorization profile is necessary (see
accounts and authorization profiles", page
free access must be open (see
5. 6. 2

Preparing Configuration with AIMS Offline

The complete configuration of a PBX can be created on the PC without access to
the PBX and stored in the database. When this is done, data can be read in from the
Project Manager and supplemented. The prepared configuration can then be up-
loaded to the PBX.
152
Reset PBX
Channel" carry out an initialization using the cor-
"Password-free access", page
". If the sales channel is also to
137) or the local, password-
143).
"User
Configuration