Yamaha FZ09E Service Manual page 87

1. Air filter case joint clamp
2. ECU (engine control unit)
3. Air filter case
4. Throttle body
5. Clip
6. Cylinder head breather hose
7. Throttle cable (decelerator cable) (white plating)
8. Throttle cable (accelerator cable) (black plating)
9. Injector lead
1 O . Injector coupler
11. Fuel rail
12. Fuel hose (black side)
13. Canister purge hose (for California only)
A. Install the breather hose on the yellow paint mark
side to the air filter case, with its yellow paint mark
facing toward left side of the vehicle.
Point the end of the clip toward left.
B. Install the b reather hose so that the tip touches the
pipe o f the cylinder head.
Install the breather hose on the white paint mark
side to the engine.
Install the breather hose so that the white paint
mark is in the rear of the vehicle and parallel to the
cylinder head mating surfaces.
Install the clip so that the end is in the rear of the
vehicle and parallel to the cylinder head mating
surfaces.
C. Install the ECU harness by storing it in the recess
in the air filter case.
D. Install the ECU so that the hooks on the air filter
case go over the ECU edges.
E. Store the throttle cables on the protrusion of the air
filter case.
F. Insert the injector coupler all the way in.
G. Instructive drawing for assembling the throttle
cables
H. Install the throttle cable so that the nut o f the throt-
tle cable touches the stay.
CABLE ROUTING
2-52