Yamaha FZ09E Service Manual page 197

j. Install the washer and cap bolt, and then fin-
ger tighten the cap bolt.
EWAl $$70
AwARNING
Always use a new cap bolt 0-rlng.
k. Hold the cap bolt "5" and tighten the locknut
"3" to specification.
Locknut
15 Nm (1.5 m·kgf, 11 ft·lbf)
I. Remove the rod holder and fork spring com-
pressor.
••••••••••••••••••••••••••••••••
16.lnstall:
• Fork spring (Right side) " 1"
• Spacer (Right side) "2"
• Locknut (Right side) "3"
• Damper adjusting rod "4"
• Washer (Right side) "5"
• Cap bolt (Right side) "6"
(along with the 0 -ring
IH¥j)
5
6
3~~
,
1
••••••••••••••••••••••••••••••••
a. Remove the rod puller and rod puller attach-
ment.
b. Install the fork spring.
TIP - - - - - - - - - - - - - - -
lnstall the fork spring with the smaller diameter
"a" facing up "A".
FRONT FORK
- -- A
---- ~
- - - - -1 - ' - --" - ""'
----
-·- '"'
,_, _
- ~
-
Ja
- - -'<:)
- - - - - - ,_ A · - l- 'V
------ I- - '- . . . . .
------ · ' -
c. Install the locknut all the way onto the damper
rod assembly.
d. Install the rod puller and rod puller attach-
ment.
e. Install the spacer.
f. Install the fork spring compressor.
g . Press down on the spacer with the fork spring
compressor "1".
h. Pull up the rod puller and install the rod holder
"2" between the locknut "3" and the spacer
"4".
Rod puller
90890-01437
Universal damping rod bleeding
tool set
YM·A8703
Rod puller attachment (M10)
90890-01436
Universal damping rod bleeding
tool set
YM-A8703
Fork spring compressor
90890-01441
YM-01441
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
TIP - - - - - - - - - - - - - - -
Use the side of the rod holder that is marked "B".
1.
Remove the rod puller and rod puller attach·
ment.
4-57