Yamaha FZ09E Service Manual page 14

To set the clock
1. Tum the key to "ON".
2.
Push the "SELECT" button and "RESET' but-
ton together for at least two seconds.
3.
When the hour digits start flashing, push the
"RESET' button to set the hours.
4. Push the "SELECT' button, and the minute
digits will start flashing.
5.
Push the "RESET' button to set the minutes.
6. Push the "SELECT" button and then release
it to start the clock.
Fuel meter
1 2
1.
Fuel meter
2.
Fuel level warning indicator
"il"
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear towards "E" (Empty) as the fuel level
decreases. When the last segment and fuel level
warning indicator
"i l"
start flashing, refuel as
soon as possible.
TIP ~~~~~~~~~~~~~~­
This fuel meter is equipped with a self-diagnosis
system. If a problem is detected in the electrical
circuit, the following cycle is repeated until the
malfunction is corrected: fuel level segments
and fuel level warning indicator
"il"
flash eight
times, then go off for approximately 3 seconds.
(Refer to "CHECKING THE FUEL METER/ FU-
EL LEVEL WARNING LIGHT" on page 8-1 05.)
Eco indicator
1
1. Eco indicator "ECO"
1-5
FEATURES
This indicator comes on when the vehicle is be-
ing operated in an environmentally friendly, fu-
el-efficient manner. The indicator goes off when
the vehicle is stopped.
TIP ~~~~~~~~~~~~~~­
Consider the following tips to reduce fuel con-
sumption:
• Avoid high engine speeds during acceleration.
• Travel at a constant speed.
• Select the transmission gear that is appropri-
ate for the vehicle speed.
Trans mission gear display
1 2
~~ (x)~.0
~~
' "
...
"
:::::--- ,,,111111111111111111111n.111
•"''' ___._,Jl ••••• "
11 111 BDN/I1fl"'
tr••••~
0
f•IJll
, ~ -~
SSEIBBB ... '
-~ass;~se
1.
Transmission gear display
2. Neutral indicator light " N •
This display shows the selected gear. The neu-
tral position is indicated by " - • and by the neutral
indicator light.
Drive mode d isplay
1
1 . Drive mode display
This display indicates which drive mode has
been selected: "STD", "A" or "B". For more de-
tails on the modes and on how to select them,
refer to "D-mode (drive mode)" on page 1-8.