Yamaha FZ09E Service Manual page 99

1. Positive battery lead
2. Starter relay
3. Fuse box
4. Positive battery terminal
5. Battery
6. Radiator fan motor relay
7. Negative battery lead
8. Negative battery terminal
9. Turn signal/hazard relay
1 O . Relay unit
11. Clamp
12. Tail/brake light coupler
13. Yamaha diagnostic tool coupler
14. Battery box
15. Starter motor lead
16. Stator coil lead
17. Wire harness (to rectifier/regulator)
18. Wire harness
A. Install the rubber bracket of the starter relay in the
battery box.
B. Install the rubber bracket of the radiator fan motor
relay in the battery box. Make sure to route the
negative battery lead under the relay.
C. Install the rubber bracket of the turn signaVhazard
relay in the battery box.
D. Install the clamp into the hole in the battery box.
E. Connect each rear turn signal coupler to the cou·
pier with the same color. After connecting the
license plate light connector, store the turn signal
light coupler (left/right) furthest to the bottom of the
vehicle. After connecting the other couplers. store
them below the taiVbrake light lead.
F. Route the tail/brake light lead, tum signal light
lead, and license plate light lead through the cut·
out of the battery box. The order of the leads does
not matter.
G. Fasten the wire harness side of the tail/brake light
lead to the battery box.
H. Insert the rubber bracket of the Yamaha diagnostic
tool coupler to the battery box.
I. Instructional drawing for routes in the front of the
battery
J. Fasten the crankshaft position sensor lead of the
wire harness with tape.
CABLE ROUTING
2-64