Yamaha FZ09E Service Manual page 125

••••••••••••••••••••••••••••••••
5. Install:
• Upper bracket
Refer to "HANDLEBAR" on page 4-44.
EAS1RC l 321
LUBRICATING THE STEERING HEAD
1. Lubricate:
• Upper bearing
• Lower bearing
• Bearing races
l
EA$1AC1322
Recommended lubricant
Lithium-soap-based grease
CHECKING THE CHASSIS FASTENERS
Make sure that all nuts, bolts, and screws are
properly tightened.
Refer to "CHASSIS TIGHTENING TORQUES"
on page 2-1 8.
EAS1RC I XG
LUBRICATING THE BRAKE LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
Recommended lubricant
1-mtl Silicone grease
EAS1AC1XM
LUBRICATING THE CLUTCH LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
l
Recommended lubrlcant
Lithium-soap-based grease
LUBRICATING THE PEDAL
Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
l
Recommended lubricant
Lithium-soap-based grease
PERIODIC MAINTENANCE
.....
,,
..
ADJUSTING THE SHIFT PEDAL
TIP ~~~~~~~~~~~~~~~
The shift pedal position is determined by the in-
stalled shift rod length.
1. Measure:
• Installed shift rod length "a"
Incorrect~
Adjust.
2. Adjust:
Installed shift rod length
256.9-258.9
mm
(10.11-10.19
in)
• Installed shift rod length
••••••••••••••••••••••••••••••••
a. Loosen both locknuts "1 ".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction " b"
Installed shift rod length decreases.
c. Tighten both locknuts.
d. Make sure the installed shift rod length is
within specification.
EAS 1 AC1~
CHECKING THE SIDESTAND
1. Check:
• Sidestand operation
Check that the sidestand moves smoothly.
3-19