Yamaha FZ09E Service Manual page 79

1.
Throttle cable
2.
Meter lead
3.
Meter assembly
4. Left handlebar switch lead
5. Horn lead
6.
Wire harness
7. Right handlebar switch lead
8.
Main switch lead
9.
Horn lead
1
O .
Handlebar switch coupler
11. Headlight
12. Front brake hose
13. Turn signaVposition light assembly (lefVright)
14. Flap
A. Route the right handlebar switch lead to the rear of
the meter lead.
B. Fasten the throttle cables and front brake hose at
the center of the metal part with the clamp as
shown in the illustration . Face the ca tch o f the
clamp on the front brake hose side downward.
C. Route the main switch lead to the cable guide from
the top of the vehicle.
D. Route the meter lead behind the throttle cables.
E. Fasten the left handlebar switch lead with the
clamp so that the jointed part is facing upward.
F. Fasten the left handlebar switch lead and right
handlebar switch lead with the clamp.
G. Fasten the horn lead to the stay with the clamp so
that the mating section faces downward.
H. Align the horn lead and the brake hose with the
brake hose protector and fasten them to the stay
with the clamp.
I. Fasten the brake hose and the horn lead with the
headlight clamp.
J . Clamp the wire harness, and then fasten it to the
stay.
Hook the either catch of the clamp onto the stay.
K. Outtine d rawing of around the meter lead
L. To Meter
M. To hand lebar switch (lefVright)
N. To turn signal/position light (lefVright)
To auxiliary light
O. Front o f the vehicle
P.
Fasten the left handlebar switch coupler to the
headlight.
Q .
Route the brake hose through the inside o f the
headlight cover.
R. Fasten the right handlebar switch coupler to the
headlight. The order and connection o f the leads
on the wire harness behind headlight do not mat·
ter.
$ .
Fasten the auxiliary light coupler to the coupler
fastened to the headlight.
T. Make sure that the lead of the wire ha rness p ro-
trude from the bottom side o f the vehicle.
U. Insert the flap up to the sides o f the arrow.
CABLE ROUTING
2-44