Installing The Swingarm - Yamaha FZ09E Service Manual

• Collars "3"
Damage/scratches -> Replace.
• Bearings
"4"
Damage/pitting
4
Replace.
4 2
2 3
\ ~
\b()
''""'""
INSTALLING THE SWINGARM
1. Lubricate:
• Dust covers
• Pivot shaft
• Oil seals
• Collars
•
2. Install:
Recommended lubricant
Lithium-soap-based grease
• Bearings
"1"
(to the swingarm)
• Oil seals "2'
1
l@t@i
(to the swingarm)
Installed depth " a"
2.0 mm (0.08 in)
Installed depth " b "
9.0 mm (0.35 in)
Installed depth " c"
0.5-1 .5 mm (0.02-0.06 in)
Installed depth " d "
7.0 mm (0.28 in)
Installed depth " e"
1.5-2.5 mm (0.06-0.1 O in)
TIP ~~~~~~~~~~~~~~
When installing the oil seals to the swingarm,
face the character stamp of the oil seals outside.
SWINGARM
e -.....= - - e
fl
A. Left side
B. Right side
3. Install:
• Swingarm
• Pivot shaft
Pivot shaft nut
11 O Nm (11 m-kgf, 80 ft-I bf)
4 . Install:
• Drive chain
Refer to "INSTALLING THE DRIVE CHAIN"
on page 4-73.
• Connecting arm lower bolt
• Connecting arm lower nut
Connecting arm lower nut
55
Nm
(5.5
m-kgf,
40
ft-lbf)
• Rear wheel
Refer to "REAR SHOCK ABSORBER AS-
SEMBLY'' on page 4-63 and "REAR WHEEL"
on page 4-14.
5. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-16.
Drive chain slack
5.0-15.0 mm (0.20--0.59 in)
4-69