Yamaha FZ09E Service Manual page 95

1. Injector coupler #1
2. Injector coupler #2
3. Clamp
4. Ignition coil #1 coupler
5. Ignition coil #2 coupler
6. Air cut-off valve coupler
7. Ignition coil #3 coupler
8. Fuel injector coupler #3
9. Throttle position sensor coupler
1 O . Throttle servo motor coupler
11. C ross tube
12. Accelerator position sensor coupler
13. Pressure sensor coupler
14. Air induction system hose (air filter case to air
cut-off valve)
15. Clutch cable
16. Air cut-off valve
17. Air filter case
18. ECU (engine control unit)
19. ECU (engine control untt) coupler
A. Fold back the intake air pressure sensor lead by
the coupler, and then fasten it with tape.
B. Insert the clamp into the fuel rail hole.
C. Fold back the injector lead #1 by the coupler, and
then fasten
tt
with tape.
D. Connect the sub-lead to the injector coupler #2.
Fasten the injector coupler on the wi re harness
side with tape.
E. For the air cut-off valve lead, ignition coil lead #3,
and fuel injector lead #3, it does not matter which
is routed above the others.
F. Route the coolant tempera ture sensor sub-lead
between the cross tube and the wire harness.
G. Fasten the fuel hose at the mark and the wire har-
ness at the positioning tape with the clamp. The
opening of the clamp can face either
way.
H. Rou le the clutch cable above to the air induction
system hose (air filter case to air cut-off valve).
I. Route the ECU lead for the front of the vehicle
through the rib of the air filter case.
CABLE ROUTING
2-60