Yamaha FZ09E Service Manual page 130

£CA13300
NOTICE - - - - - - - - - - - -
Make sure the 0-rlng " 3" Is positioned cor-
rectly In the groove of the oll filter cartridge.
3
c. Tighten the new oil filter cartridge to specifi-
cation with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
••••••••••••••••••••••••••••••••
6. Install:
• Engine oil drain bolt
(along with the gasket
1emw
l
Engine oil drain bolt
43 Nm (4.3 m -k,gf, 31 ft·lbf)
7. Fill:
•Crankcase
(with the specified amount of the recom-
mended engine oil)
·' D >
Engine oil quantity
Quantity (disassembled)
8. Install:
3.40 L (3.59 US qt, 2.99 Imp.qt)
Without oil fi lter cartridge re-
placement
2.40 L (2.54 US qt, 2.11 Imp.qt)
With oil filter cartridge replace-
ment
2.70 L (2.85 US qt, 2.38 Imp.qt)
• Engine oil filler cap
(along with the 0 -ring
IH£11)
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• Engine
(for engine oil leaks)
11.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
PERIODIC MAINTENANCE
LEVEL" on page 3-22.
"""""'
MEASURING THE ENGINE OIL PRESSURE
1. Check:
• Engine oil level
Below the minimum level mark "a"
--+
Add the
recommended engine oil to the proper level.
2. Start the engine, warm it up for several min-
utes, and then tum it off.
ECA13'10
NOTICE
When the engine is cold, the engine oil will
have a higher viscosity, causing the engine
oil pressure to increase. Therefore, be sure
to measure the engine oil pressure after
warming up the engine.
3. Remove:
• Main gallery bolt "1"
ew ...
1MO
A wARNING
The engine, muffler and engine oll are ex-
tremely hot.
4. Install:
• Oil pressure gauge "1"
3-24
• Adapter "2"
Pressure gauge
90890-03153
YU-03153
Oil pressure adapter H
90890-03139